Related terms
- Irradiance
- Power density. How much light power falls on each square centimeter of skin, measured in milliwatts per square centimeter (mW/cm²). Sometimes called intensity.
- Joule and wattJ, W
- A joule is a unit of energy and a watt is a unit of power. One watt delivers one joule every second. A device's power in watts says how fast it delivers light, and joules say how much it delivered in total.
- Beam area
- Also called spot size. The area of skin that the light covers, in square centimeters. The same power spread over a smaller area gives a higher irradiance, so a paper that leaves out the area leaves the dose unclear.
Research that mentions power output
7 studies in our archive have this term in the title. The newest are below.
Pre-Exercise Infrared Photobiomodulation Therapy (810 nm) in Skeletal Muscle Performance and Postexercise Recovery in Humans: What Is the Optimal Power Output?
PBMT with 100 mW power output per diode (500 mW total) before exercise achieves best outcomes in enhancing muscular performance and postexercise recovery.
What is the ideal dose and power output of low-level laser therapy (810 nm) on muscle performance and post-exercise recovery? Study protocol for a double-blind, randomized, placebo-controlled trial
We believe that, unlike drug therapy, LLLT has a biphasic dose-response pattern. TRIAL REGISTRATION: The protocol for this study is registered with the Protocol Registry System, ClinicalTrials.gov identifier NCT01844271.
The effect of increased maximum power output on perioperative and early postoperative outcome in photoselective vaporization of the prostate
With the 180-W laser, higher energy application and higher speed of tissue vaporization leads to increased tissue vaporization compared to the former 120-W and 80-W laser systems.
Evaluation of microleakage of root canal fillings irradiated with different output powers of erbium, chromium:yttrium-scandium-gallium-garnet laser
Statistically significant differences were detected between groups. Irradiation at 1 and 2 W using an erbium, chromium:yttrium-scandium-gallium-garnet laser produced a seal superior to that of the other treatments.
In vitro analysis of human tooth pulp chamber temperature after low-intensity laser therapy at different power outputs
The study showed that diode laser irradiation with a wavelength of 808 nm at 417 mW power output increased the pulp chamber temperature of certain groups of teeth, especially incisors and premolars, to critical threshold values for the dental pulp (5.5°C).
Effect of low-level laser therapy with output power of 30 mW and 60 mW in the viability of a random skin flap
LLLT (660 nm) with 30-mW and 60-mW output power was efficient in the increase of skin flap viability, but there was no difference between them.
Read this with care
- This entry is general information, not medical advice. See the disclaimer.
- Definitions are written for readers new to the field and may be simplified. Check the full paper when it matters.
- Found a mistake? Tell us.