AI-generated summary
The authors report a randomized clinical trial of 20 patients comparing a minimalistic ridge augmentation technique with and without low-level laser therapy to widen narrow alveolar ridges. Both groups showed horizontal ridge width gains greater than 2 mm, and there was no statistically significant difference between groups in bone density changes. The authors conclude the technique is simple and feasible, but state that the role of laser therapy requires further study.
- Participants
- 20
- Who or what was studied
- Patients with narrow alveolar ridges (dental defects) undergoing ridge augmentation
- Wavelengths
- 810 nm
- Limits stated in the abstract
- The abstract describes a small sample of 20 patients and states that the role of low-level laser therapy requires further elucidation.
Written by an AI model from this paper’s abstract only and checked automatically against it, but it can still be wrong. It is not medical advice. Read the full paper. See the editorial policy.
Abstract
Background And Objective
A narrow alveolar ridge is an obstacle to optimal rehabilitation of the dentition. There are several complex and invasive techniques to counter the ridge augmentation dilemma, with most of them exhibiting low feasibility. Hence, this randomized clinical trial aims to evaluate the effectiveness of a Minimalistic Ridge Augmentation (MRA) technique, in conjunction with low-level laser therapy (LLLT).
Materials And Methods
A total of 20 patients (n = 20) were selected, with 10 assigned to the test group (MRA+LLLT) and the other 10 to the control group (MRA). A vertical incision of approximately 10 mm was placed mesial to the defect and tunneled to create a subperiosteal pouch across the entire width of the defect. At the test sites, a diode laser (AnARC FoxTM Surgical Laser 810 nm) was used to deliver LLLT (parameters: 100 mW, with a maximum energy distribution of 6 J/cm2 in the continuous wave mode for 60 s per point) to the exposed bone surface inside the pouch, followed by graft (G-Graft, SurgiwearTM, Shahjahanpur, India) deposition with a bone graft carrier. The control sites were not irradiated with a laser.
Results
A horizontal ridge width gain of >2 mm was observed in both groups. The changes in bone density for the test and control groups were -136 ± 236.08 HU and -44.30 ± 180.89 HU, respectively. Furthermore, there was no statistically significant difference between the test and control groups in these parameters.
Conclusion
The study findings reveal that the MRA technique is relatively simple and feasible for alveolar ridge augmentation. The role of LLLT in the process requires further elucidation.
Abstract reproduced under the CC BY license. Source: PubMed, a service of the National Library of Medicine.
Light parameters mentioned
Found in the title and abstract by pattern. They may be incomplete, so check the paper before comparing studies.
- Wavelength
- 810 nm
- Energy density (fluence)
- 6 J/cm2
- Power
- 100 mW
How to read a trial: what to check before relying on this kind of research.
Terms in this paper: Low-level laser therapy, Laser, Control group. Each links to its definition in the glossary.
A summary of published research, not medical advice. One study rarely settles a question. See the disclaimer and how to read research.