AI-generated summary
This laboratory study compared three surface pretreatments for resin matrix ceramic discs before bonding composite resins of different viscosities, then tested bond strength after artificial aging. The authors report that the Er, Cr: YSGG laser produced the roughest surfaces, and that low-viscosity injectable composite achieved higher bond strength than high-viscosity micro-hybrid composite. Because this was an in vitro study on discs rather than patients, its findings may not apply directly to clinical repairs.
- Who or what was studied
- Resin matrix ceramic discs (78 discs in total) bonded with two composite types, tested in vitro
- Limits stated in the abstract
- The study was conducted in vitro on ceramic discs with small subgroup sizes and one prepared sample per group for topography analysis, so results may not reflect clinical performance.
Written by an AI model from this paper’s abstract only and checked automatically against it, but it can still be wrong. It is not medical advice. Read the full paper. See the editorial policy.
Abstract
The full abstract is not shown here because it is protected by the publisher’s copyright. Read it on linkinghub.elsevier.com.
Record from PubMed, a service of the National Library of Medicine.
How to read a single study: what to check before relying on this kind of research.
Terms in this paper: Low-level laser therapy, Laser. Each links to its definition in the glossary.
A summary of published research, not medical advice. One study rarely settles a question. See the disclaimer and how to read research.