AI-generated summary
The authors reviewed the photobiomodulation literature on red light and classified studies by power density and exposure time, reporting a range of 10 to 5000 mW/cm2 and 10 s to 3000 s. They also tested off-the-shelf LEDs and report that about 18 mW of input power produced an average of 100 mW/cm2 over 1 cm2, with a design rule proposed for implants. The paper is a survey and principal study rather than a clinical trial of effectiveness.
- Who or what was studied
- unclear
- Limits stated in the abstract
- The abstract reports no clinical outcome data in people, and the number of reviewed studies is not stated.
Written by an AI model from this paper’s abstract only and checked automatically against it, but it can still be wrong. It is not medical advice. Read the full paper. See the editorial policy.
Abstract
The full abstract is not shown here because it is protected by the publisher’s copyright. Read it on ieeexplore.ieee.org.
Record from PubMed, a service of the National Library of Medicine.
Light parameters mentioned
Found in the title and abstract by pattern. They may be incomplete, so check the paper before comparing studies.
- Power density (irradiance)
- 10 mW/cm2, 5000 mW/cm2, 100 mW/cm2
- Power
- 18 mW
How to read a single study: what to check before relying on this kind of research.
Terms in this paper: Photobiomodulation, Photobiomodulation therapy, Near-infrared, Light-emitting diode. Each links to its definition in the glossary.
A summary of published research, not medical advice. One study rarely settles a question. See the disclaimer and how to read research.