AI-generated summary
The authors tested an injectable chitosan hydrogel scaffold combined with photobiomodulation at 660 nm in stem cells from the apical papilla (in vitro) and in a rodent tooth model (in vivo). They report higher viability, proliferation and migration of the cells in vitro with photobiomodulation, and pulp-like tissue formation inside the root canal in vivo. The authors suggest the approach could improve future dental pulp regeneration, but the study is preclinical.
- Who or what was studied
- Stem cells from the apical papilla (in vitro) and a rodent orthotopic dental pulp regeneration model (in vivo).
- Wavelengths
- 660 nm
- Limits stated in the abstract
- The study is preclinical, using cell culture and a rodent model, and the abstract does not report a sample size.
Written by an AI model from this paper’s abstract only and checked automatically against it, but it can still be wrong. It is not medical advice. Read the full paper. See the editorial policy.
Abstract
Background
The regeneration of dental pulp, especially in cases of pulp death of immature teeth, is the goal of the regenerative endodontic procedures (REPs) that are based on tissue engineering principles, consisting of stem cells, growth factors, and scaffolds. Photobiomodulation therapy (PBMT) showed to improve dental pulp regeneration through cell homing approaches in preclinical studies and has been proposed as the fourth element of tissue engineering. However, when a blood clot was used as a scaffold in one of these previous studies, only 30% of success was achieved. The authors pointed out the instability of the blood clot as the regeneration shortcoming. Then, to circumvent this problem, a new scaffold was developed to be applied with the blood clot. The hypothesis of the present study was that an experimental injectable chitosan hydrogel would facilitate the three-dimensional spatial organization of endogenous stem cells in dental pulp regeneration with no interference on the positive influence of PBMT.
Methods
For the in vitro analysis, stem cells from the apical papilla (SCAPs) were characterized by flow cytometry and applied in the chitosan scaffold for evaluating adhesion, migration, and proliferation. For the in vivo analysis, the chitosan scaffold was applied in a rodent orthotopic dental pulp regeneration model under the influence of PBMT (660 nm; power output of 20 mW, beam area of 0.028 cm2, and energy density of 5 J/cm2).
Results
The scaffold tested in this study allowed significantly higher viability, proliferation, and migration of SCAPs in vitro when PBMT was applied, especially with the energy density of 5 J/cm2. These results were in consonance to those of the in vivo data, where pulp-like tissue formation was observed inside the root canal.
Conclusion
Chitosan hydrogel when applied with a blood clot and PBMT could in the future improve previous results of dental pulp regeneration through cell homing approaches.
Abstract reproduced under the CC BY license. Source: PubMed, a service of the National Library of Medicine.
Light parameters mentioned
Found in the title and abstract by pattern. They may be incomplete, so check the paper before comparing studies.
- Wavelength
- 660 nm
- Energy density (fluence)
- 5 J/cm2
- Power
- 20 mW
How to read a single study: what to check before relying on this kind of research.
Terms in this paper: Photobiomodulation therapy, Photobiomodulation, Power output, Beam area. Each links to its definition in the glossary.
A summary of published research, not medical advice. One study rarely settles a question. See the disclaimer and how to read research.